Wireless contact converter (230V) – RFSG-1M

  • WIRELESS CONTACT CONVERTER IS SUITABLE FOR THE TRANSFER OF INFORMATION ON SWITCHING LOW/HIGH TARIFF
  • THANKS TO THE NETWORK SUPPLY IT IS MOSTLY INTENDED FOR FREQUENT SIGNAL TRANSMISSION TO CONTROL APPLIANCES, DEVICES ETC.
  • THE POSSIBILITY TO SET SCENES – BY ONE TOUCH YOU CAN CONTROL MORE INELS RF CONTROL UNITS.
  • IN CASE OF MOUNTING THIS CONTROLLER INTO A METAL SWITCHBOARD, USE AN EXTERNAL ANTENNA AN-E TO IMPROVE SIGNAL TRANSFER.
  • “TEST” BUTTON ON THE CONTROLLER USED FOR ASSIGNMENT TO THE SWITCHING UNIT.
  • WHEN CONNECTED TO INPUT TERMINALS S – S, IT PERIODICALLY TRANSMITS THE “SWITCH ON” SIGNAL AT 10-MINUTE INTERVALS.

• This wireless contact converter is especially appropriate for wireless
transmission of information on switching HDO.
• Thanks to the network supply, it can also be used for partial transmission of information for control of an appliance or device.
• One-module design of the unit with mounting into switchboard.
• After leading in power to the “S” terminals, it periodically transmits the
command switch on in an interval of 10 min. When disconnecting the
power supply, immediately switch off .
• The button TEST on the controller is used to assign to a switching unit.
• Option of setting light scenes, where with a single press, you can control multiple units of iNELS RF Control.
• The package includes an internal antenna AN-I , in case of locating the
converter in a metal switchboard, you can use the external antenna
AN-E for better signal reception.
• Range up to 160 m (in open space), if the signal is insuffi cient between
the controller and unit, use the signal repeater RFRP-20 or protocol
component RFIO2
that support this feature.
• Communication frequency with bidirectional protocol iNELS RF Control

Reviews

There are no reviews yet.

Be the first to review “Wireless contact converter (230V) – RFSG-1M”

Your email address will not be published. Required fields are marked *

Shopping Cart