RFSET-SW2-Z1

• The switching unit with 1 output channel is used to control appliances, lights (easy to integrate it to control garage doors or gates).
• They can be combined with detectors, controllers, iNELS RF Control
or system components.
• The BOX design lets you mount it right in an installation box, a ceiling
or controlled appliance cover.
• It enables connection of the switched load up to 16 A (4 000 W).
• RFSA-11B: single-function design – switch on / off .
• RFSA-61B: multi-function design – button, impulse relay and time
function of delayed ON or OFF with time setting of 2 s-60 min.
• The switching unit may be controlled by up to 25 channels (1 channel
represents 1 button on the controller).
• The programming button on the unit is also used for manual control
of the output.
• Memory status can be pre-set in the event of a power failure.
• For components it is possible to set the repeater function via the RFAF
/ USB service device.
• Range up to 200 m (in open space), if the signal is insuffi cient between
the controller and unit, use the signal repeater RFRP-20 or protocol
component RFIO2
that support this feature.
• Communication frequency with bidirectional protocol iNELS RF Control2
(RFIO2
).