• DCDA-33M is a dimming unit designed to dim single-color and RGB
LED light sources controlled by variable current.
• The actuator has three independent channels and each output channel is individually addressable and controllable.
• DCDA-33M actuator can be controlled from the BUS, DALI or DMX.
• When controlling the unit from the BUSes and DMX, also the fourth
virtual channel can be supported to control overall brightness
(BUS – set in iDM3, DMX – set by long press of the PRG button).
• DCDA-33M can directly control from the system iNELS where the communication interface is the installation BUS.
• If for controlling, a communication interface DALI or DMX is used, it is
possible to use the master unit EMDC-64M.
• The supply voltage of the dimming unit must be at least 4V higher
than the expected output voltage on the load.
• Setting the communication interface and addresses of actuators is
performed using DIP switches:
a) switch No. 1
– In the upper position determines DALI or BUS
– In the lower position determines DMX
b ) switch No. 2 (if that switch 1 is in the upper position)
– In the upper position determines DALI
– In the lower position determines BUS
• Using the control buttons on the front panel, you can manually control the output.
• The input circuits of communication interfaces are optically isolated
from the supply voltage connected lamp unit, and is therefore resistant to electromagnetic interference.
• DCDA-33M in 3-module is designed for panel mounting on DIN rail
EN60715.
Dimming actuator 3-channel DCDA-33M/RGB
- FOR DIMMING LED AND RGB SOURCES 12-24 V DC BY ALTERNATING CURRENT
- DCDA-33M/RGB DIMMING ACTUATOR IS DESIGNED FOR DIMMING RGB AND LED LIGHT SOURCES WITH POWER SUPPLY 12-24 V DC, WHICH ARE CONTROLLED BY VARIABLE CURRENT.
- THE ACTUATOR HAS THREE INDEPENDENT CHANNELS AND EACH OUTPUT CHANNEL IS INDIVIDUALLY ADDRESSABLE AND CONTROLLABLE.
- IF DESIRED, THE CHANNELS CAN BE ASSOCIATED AS A SINGLE ACTUATOR FOR ACTUATING THE RGB SOURCE.
- DCDA-33M/RGB ACTUATOR CAN BE CONTROLLED FROM THE BUS DALI, DMX OR BUS.
- DCDA-33M/RGB CAN DIRECTLY CONTROL FROM THE SYSTEM INELS WHERE THE COMMUNICATION INTERFACE IS THE INSTALLATION BUS.
- IF ITHE COMMUNICATION INTERFACE DALI OR DMX IS USED, THE DALI MASTER EMDC-64M CAN BE USED.
SETTING THE COMMUNICATION INTERFACE AND ADDRESSES OF ACTUATORS IS PERFORMED USING DIP SWITCHES:
A) SWITCH NO. 1
- IN THE UPPER POSITION DETERMINES DALI OR BUS
- IN THE LOWER POSITION DETERMINES DMX
B ) SWITCH NO. 2 (IF THAT SWITCH 1 IS IN THE UPPER POSITION)
- IN THE UPPER POSITION DETERMINES DALI
- IN THE LOWER POSITION DETERMINES BUS
- USING THE CONTROL BUTTONS ON THE FRONT PANEL, YOU CAN MANUALLY CONTROL THE OUTPUT.
- THE INPUT CIRCUITS OF COMMUNICATION INTERFACES ARE OPTICALLY ISOLATED FROM THE SUPPLY VOLTAGE CONNECTED LAMP UNIT, AND IS THEREFORE RESISTANT TO ELECTROMAGNETIC INTERFERENCE.
- DCDA-33M/RGB IN 3-MODULE IS DESIGNED FOR PANEL MOUNTING ON DIN RAIL EN60715.
Reviews
There are no reviews yet.