Converter iNELS-DALI/DMX EMDC-64M

• The unit EMDC-64M is designed to control DALI electronic ballasts and
DMX receivers from the iNELS system.
• EMDC-64M enables control of up to 64 independent electronic ballasts DALI (Digital Addressable Lighting Interface) for fl uorescent
lamps, LEDs and other light sources.
• EMDC-64M also enables connection of up to 32 receivers DMX (Digital MultipleX) in a single segment. When used repeaters can control
up to 64 devices. Maximum amount of DMX controlled channels is 64
channels.
• Control from iNELS BUS System via EBM BUS.
• DIP switches on the front panel to select the control interface (DALI/
DMX).
• Addressing of DALI ballast units can be done via the central unit and
iDM3 software or via MINI USB on the front panel of the EMDC-64M
and DALI Confi gurator software.
• The required functionality is set in user project in iDM3 software.
• The unit EMDC-64M is powered from the mains voltage 230 V AC.
• DALI BUS power supply is 16V/250 mA via an EMDC-64M unit.
• The system BUS EBM is galvanically separated from the BUSes DALI/
DMX. Terminals for connecting the DALI BUS are equipped with short
circuit and surge protection.
• It is possible to connect up to 8 EMDC-64M units to one EBM BUS.
• If this concerns the last unit on a system BUS EBM, it is necessary to terminate the wire with a resistor with nominal resistance of 120 Ω. The
resistor is inside the unit, termination is made by shorting neighboring
terminals TERM and EBM+.
• The BUS DMX must be terminated at its end by a resistor with nominal
resistive value 120 Ω. The resistor for DMX BUS termination is on the
side of the EMDC- 64M inside the unit, termination is performed by
shorting adjacent terminals TERM and A.
• Updating the fi rmware of the EMDC-64M can be done through the
central unit adn software iDM3 or via MINI USB on the front panel and
EMDC-64M Flasher software. Updating through MINI USB must be
done while system BUS EBM is disconnected.
• When confi guring DALI addresses two types are necessary to distinguished:
– MASTER – this group includes sensors and detectors and one DALI
branch can connect up to 4 DALI MASTER units
• lighting intensity sensor DLS3-1
• motion detector DMD3-1
– SLAVE – electronic lighting ballast
• EMDC-64M in 3-MODULE design is designed for mounting in a control
panel on a DIN rail EN60715.