Analog controller – RFDAC-71B

• The analog controller with output 0(1)-10 V is used for:
a) dimming fl uorescent lamps (using a dimmable ballast).
b) dimming LED panels (when using a suitable dimmed source up to
50 units LP-6060-3K/6K).
c) Control of thermal actuators (TELVA).
d) control of other controllers (e.g. performance dimmers DIM-6).
• They can be combined with detectors, controllers, iNELS RF Control or
system components.
• The BOX design lets you mount it right in an installation box, a ceiling
or light cover.
• Potential free analog output 10 mA, contact relay 16 A.
• 6 light functions – smooth increase or decrease with time setting
2 s-30 min.
• When switched off , the set level is stored in the memory, and when
switched back on, it returns to the most recently set value.
• The analog controller may be controlled by up to 25 channels
(1 channel represents 1 button on the controller).
• The programming button on the controller is also used for manual
control of the output.
• The unit power supply is in the range 110-230 V AC.
• Memory status can be pre-set in the event of a power failure.
• For components it is possible to set the repeater function via the RFAF
/ USB service device.
• Range up to 200 m (in open space), if the signal is insuffi cient between
the controller and unit, use the signal repeater RFRP-20 or protocol
component RFIO2
that support this feature.
• Communication frequency with bidirectional protocol iNELS RF Control2
(RFIO2
).